Quote from: colinoutdoors on September 02, 2011, 08:18:25 PMQuote from: turnsouth on September 02, 2011, 08:07:09 PMHas anyone seen the YT video of the fellow disemboweling a ST300 with a cutoff saw? He apparently received it as a warranty exchange, and was quite dissatisfied with the flex.I'd post it, but it's just too horrid. Hi TS, I haven't seen it, been searching just now, no joy. Any chance you can post the link?PMed. I thinking that posting such a video goes against the philosophy of MT.O (At least I don't want to post it with out Dunc's, J-sews', or Def's permission)Anyone else want a PM, just ask
Quote from: turnsouth on September 02, 2011, 08:07:09 PMHas anyone seen the YT video of the fellow disemboweling a ST300 with a cutoff saw? He apparently received it as a warranty exchange, and was quite dissatisfied with the flex.I'd post it, but it's just too horrid. Hi TS, I haven't seen it, been searching just now, no joy. Any chance you can post the link?
Has anyone seen the YT video of the fellow disemboweling a ST300 with a cutoff saw? He apparently received it as a warranty exchange, and was quite dissatisfied with the flex.I'd post it, but it's just too horrid.
Oop, a bit slow to reply here, but its perfectly fine to post video links here at MTorg. Bob
By about the 1:10 mark I could tell his elevator didn't go all the way to the top floor.
Quote from: J-sews on September 04, 2011, 05:11:22 PMBy about the 1:10 mark I could tell his elevator didn't go all the way to the top floor. Do you me the "Let me put my plastic covered foot on this moving multitool while I saw one inch away from it" moment?