nice work. I wonder if I can change the blade from the CS to the PS?
Quote from: microbe on September 24, 2014, 06:13:15 PMnice work. I wonder if I can change the blade from the CS to the PS?Can't answer yes or no, hopefully someone who knows will be along.The nail file is 1.2mm thick and the PS scissors are double thickness. So if the CS blade is much thicker than 1.2mm there *may* be a problem (to solve).
Quote from: pingu on September 24, 2014, 06:26:23 PMQuote from: microbe on September 24, 2014, 06:13:15 PMnice work. I wonder if I can change the blade from the CS to the PS?Can't answer yes or no, hopefully someone who knows will be along.The nail file is 1.2mm thick and the PS scissors are double thickness. So if the CS blade is much thicker than 1.2mm there *may* be a problem (to solve).hmm... not entirely sure about this one. I've swapped the blade from a CS in place of the scissors on the PS, which would indicate that the blade tang is roughly the same thickness as the scissors. (I haven't measured.) so it sounds like some thinning would be required to fit the CS blade in place of the file on the PS.nice work on the mod, pingu! I've been meaning to try the same thing with the package opener from a Dime, I just haven't gotten around to it yet.
Looking at the OP again it looks like you don't need to thin it out, just remove the tweezer standoffs.