Tool Clip?

[ToolJoe]

I've seen pictures of the Tool Clip but there doesn't seem to be any information about it on the SOG website. Anybody have info on it?

[Chako]

 

http://wiki.multitool.org/tiki-index.php?page=ToolClip

[Smaug]

I had one. Didn't care for it. The tool package and size was good; it's about the size of a 91mm 2 layer SAK, only not quite as smooth around the edges.

The first time I tried to use the wire cutters on a piece of 10 gauge copper wire, it bent the cutters. I haven't seriously considered SOG since then. (until now)

In short, great idea, poor material choice, in an attempt to build to a low price point. They're good for collectors only, IMHO.

[AimlessWanderer]

I had one. Didn't care for it. The tool package and size was good; it's about the size of a 91mm 2 layer SAK, only not quite as smooth around the edges.

The first time I tried to use the wire cutters on a piece of 10 gauge copper wire, it bent the cutters. I haven't seriously considered SOG since then. (until now)

In short, great idea, poor material choice, in an attempt to build to a low price point. They're good for collectors only, IMHO.

Was that the full sized one, or the micro? I would be very surprised if you had that failure on a Toolclip, though maybe not as surprised on a Micro Toolclip. The original full sized toolclip is a very robust item

[lowtech]

 

http://forum.multitool.org/index.php/topic,60789.0.html

Smaug, I bet you mean the Micro Tolclip, as the Toolclip is far bigger than a 91 mm SAK.