Torx bit sizes on Leatherman knives

[DaveK]

Anyone happen to know what size torx bit the Leatherman knife pocket clips take?

It's smaller than 10, (I'm guessing , and I'm hoping to pick one up tomorrow and give some stuff a right good tightenin'

Thanks.

[Nikos]

If you're asking about the bits in the bit kit, T10 is the smallest you'll get. They come in sizes of T10, T15, T20, T25, T27 and T30.

[Roadie]

I'd guess T8 but i have no idea really!

[DaveK]

It is indeed a T8. I found a bit kit with one in and my pocket clip is tightened

Thanks for the replies folks 

[Roadie]

What a guess

[Craig]

I have a T9 bit that fits my C303.  But then it's from a very cheap kit and may be undersized

[DaveK]

I just tried the T8 in a c303 and it seems to fit well, so you could be right!

[STik]

I have craftsman jeweler's screw drivers in both T8 and T9, and while both of them fit, I believe the screws on all the LM knives are a T8, just a tad loose, like a philips screw will be sometimes.  A lot of Gerbers use these for the main pivot, and T6 for the lower screws.
STik

[J-sews]

I have craftsman jeweler's screw drivers in both T8 and T9, and while both of them fit, I believe the screws on all the LM knives are a T8, just a tad loose, like a philips screw will be sometimes.  A lot of Gerbers use these for the main pivot, and T6 for the lower screws.
STik

Maybe its a T8.5?

[STik]

Maybe its a T8.5?
[/quote]

  Hmm, mebbe...  LMs secret anti-tamper sized torx screws.  Must investigate further...