Recent Posts

Pages: 1 2 3 ... 10

The Break Room / Re: Revived Sos Surprise Box GAW ( US edition ).

« Last post by Alan K. on Today at 04:51:18 AM »

Swiss Army Knights Forum / Re: Do you carry a supplemental Sak along with another knife?

« Last post by MrToolJunkie on Today at 04:50:08 AM »

Usually a Spirit and a Pioneer X or Electrician or Serrated Spartan.

The Break Room / Re: Revived Sos Surprise Box GAW ( US edition ).

« Last post by IMR4198 on Today at 04:27:30 AM »

The box is on the move! (Did I say that right?)

General Tool Discussion / Re: Flame On! - April Firestarting Challenge

« Last post by Explorer on Today at 04:27:26 AM »

🔥DAY 17🔥

just a light carry today because i did some inspections on a friends property.

cloudy and rainy here so no mag fire attempts.

General Tool Discussion / Re: Flame On! - April Firestarting Challenge

« Last post by Explorer on Today at 04:23:57 AM »

Quote from: comis on April 17, 2024, 05:57:28 PM

Day 17

(Image removed from quote.)

A lesser known Japanese brand, Penguin, made this retro gas lighter.

very nice Penguin

The Break Room / Re: Revived Sos Surprise Box GAW ( US edition ).

« Last post by lazar on Today at 04:12:33 AM »

Got the box shipped out to BigShep today. Lady said it should get on Saturday!

Gadget Freak and EDC Forum / Re: Show Us Your EDC gear!!!

« Last post by Heywood Floyd on Today at 04:06:35 AM »

Quote from: nate j on Today at 03:48:22 AM

Couple of nice setups as always, HF!

LionSteel makes a nice blade, don’t they?

Thanks Nate,
I've got three Lionsteel blades that have been prominent in recent edc posts, namely;
Lionsteel SR-2A Black Aluminium - Sleipner 60-61 HRC
Lionsteel TRE Carbon Fiber - M390 60-61HRC
Lionsteel Roundhead Spear Jack Carbon Fiber scales & Titanium alloy bolsters - M390
Absolutely no regrets acquiring them. The only mod was a rework of the Roundhead's edge geometry. Although it came sharp it was too thick behind the edge which hindered performance. I bought it stateside from an early Collector Knives production run. I've seen much later production and they appeared to have a different and better edge geometry. In any case, now the edge works fine so it not infrequently gets a guernsey.