Home made LM bit adapter

Chaka · **on:** May 29, 2007, 06:53:51 PM

This i just did...

Cut a corner of a floppy disk bay, very soft but is 1/16" thick. Stainless Steel is probably better but this a had at hand
Insert in a long 1/4" x 1/4" socket.
Add a drop of loctite
Still needs a little magnet to hold bit in place.
Works with LM flat bits

It's hard to get LM accesories in Mexico, the delivery service charge to much.

prime77 · **Reply #1 on:** May 30, 2007, 08:38:58 AM

That's pretty sweet

J-sews · **Reply #2 on:** May 30, 2007, 01:29:21 PM

Oh I get it now! (I'm slow, it took me a moment.) The bent piece of 1/16" metal acts as a reducer, so your square phillips driver now fits snugly in a 1/4" socket receptacle! Sure, good idea!