My scissor spring has a tendency to pop out of place, no doubt aided by a bit too much rounding over at the edge of the scissor handle:(Image removed from quote.)(Image removed from quote.)Otherwise, the scissors seem to cut fine.By the way, that would be the remnants of my lunch that you see on my leg
Yes, DHL and yes (Germany)
Sounds promising! I guess I'll just have to wait. I didn't back them Om indiegogo until early January so I guess I'm a bit further down on the list..
Evenin' awl I thought I'd give the GOAT a try-out (light use) I needed to remove a string of those cheap solar powered lights that Mrs Surge had suggested that "we" might like This particular set had died a few weeks ago but I've not really been here (working overseas )The wire cutters failed miserably and just squashed the outer plastic coating and only cut through on the third attempt. However, the scissors cut like a knife through butter I tried again using my Surge and no issues with the wire cutters I'm going to try and use this thing as much as I can (no EDC in public as in the UK) but, so far, I'm struggling with the OHO being just that. If I have to use another finger to push the release lever (or anything else) back down then how is it OHO If you have any tips please let me know
Well it's a real bummer that the wire cutters turned out so bad, I really hope that they are working on a replacement part ASAP. Regarding no EDC in the UK, I find the Goat the perfect (and first) tool that i actually can EDC because i can remove or replace the blades etc. with other tools (I'm in Sweden, it's strictly forbidden to wear any form of knife or sharp tool outside of your home or work).
So, today I had cause to use the Phillips driver to adjust a few cupboard doors. It did very well and the centred bit made it very easy (not much torque needed though) However, I am looking after a neighbours garden whilst they are away and used the "hammer" to secure a post. That worked fairly well but as I walked away (triumphant, of course ) the Phillips bit fell out of the holder and, had I not been paying attention, I would have lost it (the magnet is not strong enough) Still persevering....
So you fine folks have had your GOAT tools for a few months now. How’s the usage been? I’m curious if anyone has tried theirs as a daily user and gotten a few solid months of review out of it?
Basically, I don't really carry it and it lives in its box. I'll stick with my Surge/Wave/ Vic' etc
I've wanted a GOAT (of course) since I first saw them on the horizon, but the reports from you and others have dissuaded me. The whole idea of the GOAT sounds great, but maybe they aren't ready for prime time.
@SurgeUk @Adam5 @Dutch_Tooler @pa_strunk Sent from my SM-G996U using Tapatalk