micro philips/flat ends for 4mm cybertool bit

[Raukodur]

Are there any victorinox (or 3rd party/generic) 4mm bits that fit in the cybertool bit driver which have micro philips/flat ends (the size of the ones on the LM charge mini bit driver)?

[AimlessWanderer]

try googling 4mm Wiha bits 

[Raukodur]

Excellent! So they do exist, BUT how well do they work in the cybertool driver?

[AimlessWanderer]

 Dunno

Be sure to let us know when you find out 

[Syph007]

They fit fine and work fine, but there is no little ball to retain them like vic ones.  You'll have to get creative and figure out how to keep them in.  I think dremeling a ring around the center and using an oring or tiny elastic for braces would work.  Or a tiny magnet epoxied to the inside bottom of the driver body.

[Raukodur]

These sold in the UK anywhere? Or only sold in the Status by Wiha?

[Syph007]

I bought mine off ebay.  If you search for precision screwdriver you'll find lots.  There are really cheap china ones that fit as well, but they dont last as long. I think they were 5 dollars a set though.

[Raukodur]

Thing is, especially with the very small flat bits, if low quality they just do not work; when you need to apply any sort of force at all, they deform and become useless.

So for this sort of bit, I would want VERY high quality.

[Raukodur]

Seems Amazon.co.uk was the place to go, just bought a very cheap microbit screwdriver set, for like 3 pounds with delivery, with 42 good reviews. So hopefully will be of the quality I desire. Several extra microbits as well.