Weekend project.

[baja820]

Anyone know how I could get this magnet out to make room for the leatherman bits?


Then modify this to fit the bit exchanger on my Rave and Surge.

[tattoosteve99]

Heat will make the magnet fall out . And slow grind the sides till it fits properly

[baja820]

Awesome. That's what I was thinking. Thanks

[tattoosteve99]

Anytime! Keeps up updated on the project and always pics please

[redbaron]

i'd use a beltsander or an endmill if you got one

[baja820]

  progress!  Well it fits the bit exchanger. The propane torch worked amazing to remove the magnet. It will fit the LM bits but without a magnet they fall right out.

[redbaron]

will it hold 1/4" hex fit?

[baja820]

Yes, however without the magnet the bit falls out.

[gregozedobe]

Have you tried to magnetize the whole bit holder ? (won't work if it isn't the right steel).

[tattoosteve99]

You may be able to get a smaller magnet that will work too .

[baja820]

This is worse than legos when I was a kid!

[Metropolicity]

What's wrong with the LM extender and bit kit? I've always thought about making my own, but the time it would take me to make one that I like, it would have been easier to spend $10

[baja820]

The lm bit extender is great with the lm bits but the little stubby bits fall down too deep and are a pain in the ass to get back out.