Like most on here, I can't seem to turn away from yet another MT or SAK...
Damn them. They're so addictive..
...........
Anyway, I guess we all check them over to make sure nothings loose, broken or worst rusty
.
Then what??
Me?? I clean them...I find it almost theraputical, soothing, calming....................
nurse!!!
Once established that it's just dirt, grease, paint, tar, wood resin etc etc etc but nothing major.
I put the tool and pouch into boiling water with mild detergent. then scrub everything with an old toothbrush, brillo pad etc etc the pouch is scrubbed too (nylon obviously).
Meanwhile the oven has already been turned on...
The tool is removed, patted with kitchen towels and then placed on cooking foil and put in the oven for 30mins.
If it's a SAK I remove the scales first (they're buffed up to like new using Brasso), if it's an MT and has plastic parts fitted then I place it over the floor vents (warm air heating system).
After 30mins in the oven or 1 hour over the floor grill - it's picked up with tongs taken into the garage, placed on wood and sprayed with copious amounts of WD40 (both sides of the tool) and left to cool down.
Upto now every time I've done this, they work so smoothly afterwards...slick is the word!!
The pouches are stuffed with newspaper and air dried or put over the flloor vents.
So.. (sad I know) - but does anyone have a different method??
I recently picked up the PSTII from the local free-ads, wrong pouch (placed an ad in the wanted section below
) - way too big/modern for that era. But the tool itself is okay apart from one flaw.....
The blade looks like it's been took it to bench grinder
- no bluing whatsoever, so I guess the steel temper is still okay. But the scratches...arrgh.
They're not deep at all but I'd like to get them out if possible. What's the best method??
Buffing wheel?, belt sander? I've got both but have never attempted it before and don't know really what's the best way to go about it. Ideally I'd like to recreate the "grain" of the steel as it was originally.
Any ideas would be greatly appreciated??
Thanks
Tosh