Anyone know the pin stock size for the 65mm Wengers?

[Syph007]

I was wanting to do a Ti conversion of a wenger pocket tool chest, but Ive never touched the 65mm wengers ever. Does anyone know if they happen to have the same pivot size as the Vic 58s? 

Cheers

[lowtech]

I think i remember Metro mentioned 1,5 mm as we were talking about the 65 i sent himne to mod. But it´s not my fault if that´s wrong...

[Syph007]

That would make sense it if is, as that's the size of the Vic 58s too.  Which is why I can get away with using 1/16th inch pin stock.

1.5 mm = 0.059"
1/16 inch = 0.062"

[AimlessWanderer]

I think i remember Metro mentioned 1,5 mm as we were talking about the 65 i sent himne to mod. But it´s not my fault if that´s wrong...

That makes sense as I sent him some a while back. Didn't realise he was doing 65s though, I thought it was 58s which is why I didn't reply to the thread earlier. I have a vague recollection the 85mm wenger pins are slightly larger than the 84mm vics, and kinda assumed the 65s were the same