I would like some help/advice with my first modding plans.I want to make a "maxed out" flight version of the minichamp (basically remove the two blades and reshuffle the remaining components accordingly).I also want to figure out a way to take a cybertool 34 and add the 58mm combo tool (bottle opener/phillips head piece) and either the 74mm or 58mm orange peeler to it, and likely remove the scissors as well.I think it would be neat to take a 91mm small blade and cram it into a minichamp as well, also removing the two native blades in the process. Is that feasible.TIA for any/all adviceEDIT: Instead of a maxed out flight minichamp, I would like to take a jetsetter 3 (combo-phillips + scissors, t&t), and replace the toothpick scale with a pen scale, and the scissors with the 58mm orange peeler + ruler/sd tip (any recommendations how to turn the other side of that into a file like they should have done from day 1?). Is there any way to modify a default 58mm scale to hold both the toothpick and the tweezers? parallel diagonal is what I'm thinking, but I bet those rivets would get in the way.
I'm trying to replace the main blade on a Angler (91mm), I'm looking for screw pivots to replace the rivets once I remove them.Do these only work with the Alox models, and if they would work with the Angler how do I ensure that their long enough (they don't list the measurement units on the site).http://www.knifekits.com/vcom/product_info.php?cPath=60_83&products_id=471Alternatively, I'll just use the regular pins in the guides.
I don’t know much about alox springs, but I think that if you made your own topic with an appropriate title, more people would see your question. After all, nobody reads the stickies!
I’d try the *bay seller in Germany. Has pin and bushing kits. Haven’t tried them myself, but others have here.
I don't have have any spares sadly. You might get more notice if you start a new topic in the mod squad area. Can't say for sure but I'd be surprised if there was no-one out there willing to help. Best of luck.