Haha... the whole point of that mod was about getting a medium flat in.
..if you have a plier no one needs a can opener..
Oh like this?
That's one way...but not the cleanest or fastest. I need to make a vid of the method. You need to break the lip of the lid so that it releases from the can. On a side note, I think I'm narrowing down a set of Leatherman knife setups for different activities.
Love that mod, Synco Great family pic of the LM knives, HG The Charge/Wave/Surge knives are great for me (need to make a SURGE one ) but I can see that they have plenty of limits and that is why I normally carry mine as a compliment to a regular MT
I have reason to believe that the Center drive 1/4 inch driver might even work in the surge.
Perhaps a SOG one? Easier to obtain. https://www.sogknives.com/type/accessories/1-4-driver.html
Still better than the BuckTool.
So what all did you do in this mod I believe it is bi-colored but it is a bit hard to tell in the pics
That is great but I hope that cutting the notch didn't compromise the strength of the bit driver keep us updated on how this particular mod holds up if it does then AWESOME if not then...........
I can tell already that it is substantially weaker, but does work for all buy stubborn screws and a hard crank. For me that's not acceptable. So I'll try a different solution.
Nice one Raoul