Here's a primer for you58mm-all pins 1/16th inch84mm-all pins 2.2mm.91mm- 2 pins 2.2 mm- 2 pins 2.5 mm93mm (alox)- middle pin 2.5 mm- 2 pins 3.0 mm1/16th inch, easily found online or hobby stores2.2 mm Only available from UK or non north american sources2.5 mm K&S Engineering makes it. http://www.ebay.ca/itm/NEW-K-S-Round-Brass-Rod-2-5mm-Diameter-4-9864-NIB-/390796957998?pt=Model_Kit_US&hash=item5afd50592e3.0 mm K&S Engineering makes it. http://www.ebay.ca/itm/NEW-K-S-Round-Brass-Rod-3mm-Diameter-3-9865-NIB-/291105389330?pt=Model_Kit_US&hash=item43c73bbb12If you're modding the common plastic SAKs, the 2.2 mm pins are for the center 2 which are less critical than the end ones. I would just sand down some 2.5mm. You could also hit up one of our euro breathren to hook you up with some 2.2mm from across the pond.Cheers
would it be easier to sand down 3/32" brass rod than the 2.5mm? 3/32" is only .181249 mm larger than the 2.2mm
Quote from: detron on March 25, 2014, 04:23:03 PMwould it be easier to sand down 3/32" brass rod than the 2.5mm? 3/32" is only .181249 mm larger than the 2.2mmOh good point ya. I just was meaning if you only buy 2.5mm you can use it for both, but ya 3/32 would be faster for sure. I wonder if it would work unmodified since the tolerance on those pins is pretty large.
If you do need a UK post along, I am happy to help Metro. You done me favours in the past so its about time I paid them back (if you do need to order from the UK)