91mm SAK Mod Fixture + Compact w/ Universal Wrench & Inline screwdriver mod ?

[archerwin]

I saw somewhere in this forum a photo of a fixture/jig that can hold the pins/liners/tools during mod assembly. Can you please point me to that post please.  I tried to search for "fixture" but results did not show the photo I wanted.

Also,

I'm doing this mod, as far as I know, this is a basic mod and pretty common too. But I have not seen photos of it done step-by-step. I'm planning to add the Wenger universal wrench and inline screwdriver to the Victorinox Compact.  Can you please share the step-by-step photos if you have any?  What liner did you used? What spring did you used?

Thanks a lot! I'm excited as this will be my first mod.

[lowtech]

I think the wrench/Phillips mod has been done and documented her by hanksolon (among oithers), mybe browsing his posts helps finding it?

[hiraethus]

This one?

So I went back to the workshop a saw that my plan looks realizable.
Let’s do this.

I widen the middle hole with a high speed steel drill and now it is 2.5mm

Using the saw backspring as a guide I drilled a new and precise hole on the scissors backspring. Continuous water pouring made the job easier because of the better heat removal.
3.2mm drill was required.
Fits perfectly with the liner.

(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)


(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)

(Image removed from quote.)

[rickinFL]

For 91mm you just replace the mag glass.  You may need to reduce the rest so the spring is not "proud". You may need to drill it out to 2.5mm.