Maybe if I had a better sex bolt I too would find screwing easier...
That didn't take long.
My Rebar came from factory really stiff...
Oh, also. It's not only the size of the screw, but the thread pattern and spacing is a determining factor.
And welcome to the forum
Using the kick bolt idea may work. But add bulk on each and every side unfortunately, if there was a flusher or countersunk option that be great. We have seen people here slot the screw. Not sure if there's still photos or if photobucket smurfed that up? Basically someone added a slot on the screws that would allow a flat head driver to loosen or tighten them. Oh, also. It's not only the size of the screw, but the thread pattern and spacing is a determining factor. Side note I use a little tape over the screws and handle prior to prevent any unwanted scratches and unwanted damage. Here's a sample pic of that.
Hi, could you please advice where to get those wrenches on your photo?