DoohicKey Meets Grinder.

[zoidberg]

Grinder was hungry. I fed it a DoohicKey. Sort of a win win situation really.

[zoidberg]

[pingu]

With the marvellous mini-Brewzer on a key-chain who'd use the DoohicKey to open bottles.

During recent mods I first noticed that 7mm hex wrench provides a ratchet action on 1/4" hex.  The DoohicKey opener is not flatted but my sample provides ratchet drive for 1/4" and I think it could be improved.  So this time I won't be knocking-off your exact mod but the smaller flat driver makes sense 

Or did the grinder slip 

[windson]

Nice one. I may get another one and make it into a marlin spike. Too bad it doesn't have a hole somewhere, or it would be easy to open up the wrench side.

[zoidberg]

With the marvellous mini-Brewzer on a key-chain who'd use the DoohicKey to open bottles.

During recent mods I first noticed that 7mm hex wrench provides a ratchet action on 1/4" hex.  The DoohicKey opener is not flatted but my sample provides ratchet drive for 1/4" and I think it could be improved.  So this time I won't be knocking-off your exact mod but the smaller flat driver makes sense 

Or did the grinder slip 

Actually it did.    Was suppose to be a pry bar but I hit the front edge by mistake. Happens.

Turned out for the better. Once I thinned down the driver it fits a good range of phillips and flats. And it can still pry.

[zoidberg]

Nice one. I may get another one and make it into a marlin spike. Too bad it doesn't have a hole somewhere, or it would be easy to open up the wrench side.

The metal is quite soft so drilling a hole shouldn't be too difficult.

[kirk13]

I'm relieved! I thought this might be some dodgy internet App thing

Nice bit of work Z

[zoidberg]

 

[Kampfer]

I recently gained a few lbs, maybe I should meet the grinder instead of trackmill.