Saw should fit if the hole is enlarged to the side some, not too far though because you'll want to have the liner lock function.Will probably have the same halfway stop thing like the scissors.Swap out the knurled screws for torx ones off a Ti/TTi.
I didn't realise the TTi had different screws. That's a great idea! I have to contact Loki to see if he has any. Thanks!
I think you may have to check with Loki, if the torx for the tti are long enough for the ALs. The torx on the tti are sitting recessed in the TI scales. While the knurled ones are sitting on top of the AL scales..
Loki checked again for me and you're right, they don't fit. He refunded me, guy is a gentleman.
Any other suggestions for savings my fingers from the knurls on my Charge AL?
Hmm.. Are the screws really bothering you that much? Mine is pretty comfy. I dun mind them at all.. Did u use the Loki wrench to remove them or just by pliers. Remove them again and use sand paper to round them off?