as long as the underlying SAK body is not too bulky
Hi Mac, I consider your adapter solution quite ingenious Alas, I tried it out but found that at least with the two adapters I possess, the can opener does not slip in deep enough. It just falls off as soon as I take my hand away. Did you encounter the same problem and if so, do you have a solution?
Of course it's "wobbly" and it fits loosely and it will fall if you are not holding the adapter, but the main point for me is: it gets the job done in a pinch
I use magnets in a Wera bit adapter. Holds super securely and retains the 1/4 inch bits well.I also added magnets to one of my CT wrenches. Now I can use any micro bit and it retains fine. I can also use a socket adapter for 1/4 inch bits or even an adapter for sockets. Really happy with it. YMMV. The standard bits are durable. You are just limited to what Vic sells if you stick to the ball bearing design.
The bits do have a strange knurled end on them.
To facilitate turning by hand, if the screw isn’t too tight, perhaps?
The only thing I'll say against the Cybertool M is this - It's right on the edge of having too many tools attached to each other. What do I mean? Well, sometimes it's really handy to have a pair of pliers in one hand and a screw/nut driver in the other hand.