Hi folks, apologies if this has been discussed before.
This will be my first attempt at modding. I want to take the worn scales off an old 85mm Wenger I have, and make new ones out of deer stag.
I am going to drill the pins and put in new ones that go through the new scales as well. While I am at it, I am going to replace the backside Phillips with a corkcrew. This is where I need help.
I've got an old beeat up Tinker Small lying somewhere that has the old type 5-turn grooved corkscrew. I always liked it for some reason (and I don't think Wenger ever used grooved corkscrews).
Would putting a Vic corkscrew on a Wenger be possible? Is the size of the pin holes on the tool the same?
Thanks for any help!