Did you source the CF domestically?Sent from my XT1563 using Tapatalk
I think the 3D printing will be easier if all the openings and holes point in the same direction. That will sidestep potential issues with overhangs, bridges and deformation. I might also have split that long part, maybe along the middle. That way the 3D printing of each half could start off from with a big flat surface and build up towards the curved areas. Starting with a flat surface (on the equally flat 3D printers build platform) minimizes the need for supports and manual finishing work afterwards. Maybe I'm just lazy? (Ok, just asked here, and I have it from good authority that it is true ).