Multitool.org Forum
+-

Hello Lurker! Remove this ad and much more by logging in.


Looking for cases with snaps for 111mm sak's for 2 layer, 4 and 5 layer models.

sir_mike · 3 · 450
« previous next »
Pages: 1   Go Down

us Offline sir_mike

  • *
  • No Life Club
  • ******
    • Posts: 3,528
  • It is what it isn't.
Looking for cases with snaps for 111mm sak's for 2 layer, 4 and 5 layer models.
on: November 15, 2017, 06:08:06 PM
I am looking for some cases for the 111mm liner lock sak's.  Mainly the 2 layer, 4 layer and  5 layer models.  I am looking for cases with snaps not velcro.

I will not be adding anything to them so don't want the cases too lose that causes the sak to bounce around within the pouch.

If you know of any that are made with snaps for the 111mm, please comment below.

Thx.

us Offline cody6268

  • Absolutely No Life Club
  • *******
    • Posts: 5,829
Re: Looking for cases with snaps for 111mm sak's for 2 layer, 4 and 5 layer models.
Reply #1 on: November 15, 2017, 07:13:01 PM
My Fireman carries pretty well in the nylon Buck 110 sheath.  I had this leather Browning sheath from the '70s that held it perfectly, which I found at a flea market for five bucks. I ended up giving that sheath to a buddy who had a similar era Browning knife that needed a sheath.

2017-06-26_01-22-11 by cody6268, on Flickr

2017-06-26_01-22-36 by cody6268, on Flickr
Merit Badges Start a new thread with photos of your chainsaws Participate in a Challenge thread and post a photo of a SAK-alike, aka multi-layered, knife-based pocket tools for thirty (30) consecutive days. In this challenge,  carry one(1) Pliers-based or Non-pliers multitool that we always have prejudice against, hate or even fear and post a picture everyday for 30 days Participate in a Challenge thread and post a photo of a 'folding hunter' knife that isn't a Buck 110 for thirty (30) consecutive days. Participate and contribute in Challenge thread and post a photo of either an Axe, MT/Folding knife or Fixed blade (picked at the beginning of challenge) for thirty (30) consecutive days. Participate in a Challenge thread and post a photo of a Spyderco knife for thirty (30) consecutive days. Start a new thread with photos of your titanium gear with a multitool or sak Participate  in Challenge thread and post a photo of a SAK Soldier for thirty (30) consecutive days. Participate in a challenge thread and post a photo of a SAK Cybertool (any variant), Swisschamp, Champion or Toolchest for thirty (30) consecutive days. Participate  in Challenge thread and post a photo of a Fieldmaster SAK for thirty (30) consecutive days. Participate  in Challenge thread and post a photo of a Buck 112 Ranger for thirty (30) consecutive days. Start a new thread and post a photo of the 110 knife for thirty (30) consecutive days. Start a new thread and post a photo of the leatherman (supertool, core, hacks) for thirty (30) consecutive days. Start a new thread and post a photo of the multitool for thirty (30) consecutive days. Start a new thread and post a photo of the multitool for thirty (30) consecutive days. Start a new thread and post a photo of a flashlight as part of your EDC Start a new thread and post a photo of a traditional folder for thirty (30) consecutive days. Start a new thread and post a photo of the Vic Huntsman for thirty (30) consecutive days. Start a new thread with photos of your zip ties in use Start a new thread with a photo showing the axe in use Start a new thread and post a photo of the discontinued sak/mt for thirty (30) consecutive days.

us Offline italophil

  • *
  • Hero Member
  • *****
    • Posts: 533
Re: Looking for cases with snaps for 111mm sak's for 2 layer, 4 and 5 layer models.
Reply #2 on: November 15, 2017, 07:39:57 PM
The Victorinox SwissTool Pouch should work for the 111mm knives.



 https://www.amazon.com/Victorinox-Swiss-SwissTool-Cordura-Pouch/dp/B001C53H84/
Merit Badges Start a new thread and post a photo of the multitool for thirty (30) consecutive days. Start a new thread with a photo of your custom ALOX with scissors Start a thread with photos of at least 1 MTO branded tool in your collection Must buy an item through the MTo Store Must start a thread with a photo of your camo SAK Start a new thread with a photo of custom or non standard SAK scales in your collection Start a new thread and post a photo of any gear for thirty (30) consecutive days during the MTo anniversary month. Start a new thread and post a photo of a flashlight as part of your EDC Start a new thread with photos of your Mora knives in use

Pages: 1   Go Up
 

Donations
Operational Funds

Help us keep the Unworkable working!
Donate with PayPal!
April Goal: $300.00
Due Date: Apr 30
Total Receipts: $122.41
PayPal Fees: $6.85
Net Balance: $115.56
Below Goal: $184.44
Site Currency: USD
39% 
April Donations

Community Links
Multitool.org
Multitool Gallery
Multitool Encyclopedia
SAKWiki
Swiss Army Knights

Powered by EzPortal