Why doesn't Vic make a tool with a bottle opener bottom with a can opener on top as one tool? Seems like it would save space, esp on those models with fewer layers (it would give a one layer tool with both functions) and also make space for yet another tool of some sort. Just a thought.Rich
To me, the inside edge of the combo tool isn't sharp enough to use as a can opener. I have bantams, waiters, compacts, etc. Maybe I'll try sharpening the inside edge of the combo tool on one of my bantams.Rich
Quote from: Rich S on October 10, 2017, 10:53:04 PMWhy doesn't Vic make a tool with a bottle opener bottom with a can opener on top as one tool? Seems like it would save space, esp on those models with fewer layers (it would give a one layer tool with both functions) and also make space for yet another tool of some sort. Just a thought.RichWhile the combo tool or similar would be "passable" for that, it really depends what you use or want the opening layer for. If the main goal is to pop bottle caps or open tin cans i will agree, however for me the actual intended primary function of those two tools is very low on my priority list. I use them 98% of the time as screwdriver, prybar, hex bit driver, scraper, puller, hook, etc... So if they could get all all of those functions into one tool, with the same sturdiness of the two, and with the added bonus of being a useful cap lifter and can opener i would be all for it. Until then i don't mind a whole dedicated layer for that