Loose tweezers and toothpick

[aikon2014]

I lost a couple in the past, so now I just put a small small drop of uv glue (which I use for flytying) on the backside of it, where the first grey dot is, and the friction is now awesome and it won't come out Don't know if anyone else have done this, but it's a simple solution imo

[Steinar]

Good idea! I've had that problem with wood scaled SAKs, but I had other knives where the toothpick was slightly larger, and that solved the problem. (Larger toothpick just from variation in production, not different models.)

[cbl51]

I've taken to putting a drop of crazy glue on each side of the tweezers head to build it up, and then VERY gently sand it down so it's a very snug fit in the slot.

[aikon2014]

I've taken to putting a drop of crazy glue on each side of the tweezers head to build it up, and then VERY gently sand it down so it's a very snug fit in the slot.

That is basically the same idea but different adhesive

[Ron Who]

I´ve lost a few teeth over the years, but never a toothpick. Gotta work on my priorities... 

[Mechanickal]

I had to freeze my knife to get the tweezers out and sand it down on the sides once it did.