What LM bits do you use the most?

[CallsignBadger]

I recently got the LM bit kit for my beloved Wave. I only want to carry 1 card, so I’d like to see what bits you use most, and what you’d reccomend putting in that card. By the way, this is for my EDC.

I know for a fact I will carry these bits:
-Philips #3 and #0
-Flathead 1/8 and 3/32
-The 3 largest metric Allen/hex

With the Wave, I won’t need any more Phillips or flathead drivers, so I’m basically just wondering if you’d choose to take the Torx or the standard hex.

Depending on how useful the bits seem, I may consider a slim way to carry both cards, or go the opposite way and cut down the card for just the most used bits.

[ThePeacent]

obviously it depends on your personal needs,

myself I carry the Phillips #1 and #2, Flatheads (two sizes), micro Phillips + Flathead (for glasses, small electronics, batteries, lights), Torx #6, #8, #10 and #12 (for my folding knives' picots, clips and hardware) and two Allen sizes that are not present in my Allen key set 

[surfdaworld]

Phillips and Straight bits (obviously), followed by:

• Small straight bit (terminal strips)
• Smallish Phillips bit (changing batteries in my son's toys)
• Torx T15 (Some PC cases and Club Car golf cart dashboards)
• Eyeglass driver (unlocking privacy lock doorknobs)
• Larger hex bits (door/gate closer adjustments)

Somewhat industry-specific for me, since I generally know what bits I'll need for the particular equipment that I work on the most frequently.