Leatherman Rev reassemble help

[badwolf]

Anyone have pics of a Rev disassembled, particularly the knife side 

I was attempting a little mod and while I had it in pieces all laid out thinking I'll take a picture to help put it back together, I knocked the lot off my bench 

I'm certain I've got all the parts back on the bench but there are 5x washers/spacers.

2x plastic spacers, a black one and a grey one, same thickness.

3x metal washers in three different thicknesses.

Any help would be appreciated

[Wspeed]

Oh no !!!! Sorry to hear that 
Hope you get some help soon 

[Aloha]

Someone help  .  Wish I could.  I dont have a Rev to disassemble or I would. 

[Poncho65]

No Rev here either sorry to hear it and good luck with the reassemble

[gerleatherberman]

I don't have one disassembled, but will try and picture the pivots edge-on. Will go take pics and post them in a bit.

[gerleatherberman]

I can see most of the parts and washers. This Rev has is NIB and should be indicative of how it needs to be reassembled.

[Juan el Boricua]

Badwolf, from what I remember when I modified mine:
-black plastic washer goes in between faceplate "Leatherman Rev Tm" and blade liner, where the lanyard hole is; grey plastic washer goes between package opener and rear liner/faceplate. There is also a thin metal washer between can/bottle opener and inner blade liner
-thick metal washer goes between pliers head and rear liner/faceplate, where the clip is.
-very thin bronze/brass washer between blade and liner.
-One thin metal washer between unmarked front faceplate and phillips driver, and one thin metal washer between flathead/pry bar and unmarked rear faceplate.
Sorry I cannot supply pictures, as I did not took them while doing the modifications, but I think that Gerleatherberman's are good visual references. Hope it all goes well, and to see pictures when finished!!!

[badwolf]

I can see most of the parts and washers. This Rev has is NIB and should be indicative of how it needs to be reassembled.

(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)
(Image removed from quote.)

Badwolf, from what I remember when I modified mine:
-black plastic washer goes in between faceplate "Leatherman Rev Tm" and blade liner, where the lanyard hole is; grey plastic washer goes between package opener and rear liner/faceplate. There is also a thin metal washer between can/bottle opener and inner blade liner
-thick metal washer goes between pliers head and rear liner/faceplate, where the clip is.
-very thin bronze/brass washer between blade and liner.
-One thin metal washer between unmarked front faceplate and phillips driver, and one thin metal washer between flathead/pry bar and unmarked rear faceplate.
Sorry I cannot supply pictures, as I did not took them while doing the modifications, but I think that Gerleatherberman's are good visual references. Hope it all goes well, and to see pictures when finished!!!

Thank you so much
gerleatherberman
Juan el Boricua

MTO members are bloody awesome 

Will post some pics when finished

[gerleatherberman]

 

[Wspeed]

Good to hear that you got
the help you needed badwolf 

[Juan el Boricua]