I wish there were a 1/4 inch bit adaptor for the cybertool bit driver...

[Mr. Whippy]

Nobody makes a 5 mm Hex bit for the microdrive bit driver.  If there were an adaptor for the Cybertool's bit driver, I think it would replace the skeletool for ice climbing.

Anyone try to weld an adaptor onto a sacrificial 4 mm bit?

[Neil]

I find that the CT bits barely hold in place as it is.  I would have thought the added weight of an adapter plus additional bit would make this a bit precarious.

I'd also be worried about putting too much torque on the tool 

Neil

[Teofilo]

I find that the CT bits barely hold in place as it is.  I would have thought the added weight of an adapter plus additional bit would make this a bit precarious.

I'd also be worried about putting too much torque on the tool 

Neil

I agree with Neil there. Cybers are designed for light work only, use for small screws of laptops, desktops and cellphones.

[kodiak5]

I'm sure it would be possable....... but like the fore posts, I'm afraid tourqe would be your foe.

[AndyTiedye]

The Wenger Mountain Bike SAKS (large and small) have a 5mm alan key.