Multitool.org Forum
Site Use FAQ's => New Member Forum => Topic started by: Nobody1024 on August 07, 2017, 07:13:44 PM
-
Hi everyone,
I just wanted to give a quick introduction, I have been browsing around here for the past few weeks and decided I had better become a member.
I have been using a LM Kick for the past 10 years or so, mostly at work. It has come in very handy but saw a little abuse when I first got it. Tried to remove a screw out of a deck which snapped a corner off of the small flat driver, then tried to cut it off with the soft wire cutters. We all know what happened there. I was able to reprofile the driver with a dremel and file down the wire cutters. It has been great ever since.
I decided that it's time to upgrade to a tool with a better toolset and locking tools. I've purchased a ST300 but it was a little big for work. I just got a Wave and going mod it to my liking, I think it will be awesome.
Thanks,
Phil
-
Welcome to :MTO:. :cheers:
-
Hello and welcome to MTO.
-
Welcome aboard Phil :cheers:
What mods do you have planned for the Wave?
-
Welcome Phil :cheers:
-
Welcome. There are some good threads with many Wave mods. Be sure to post what you end up with.
-
Welcome home to :MTO:
-
welcome mate
-
Welcome aboard Phil :cheers:
What mods do you have planned for the Wave?
I want to add a set of Rebar pliers for sure, 3D philips driver and an awl. I'm. It sure exactly where or how to fit them yet or what tools to take out, or which LMs are best to get them from but that's why I'm here.
-
Welcome aboard ! :cheers:
-
Welcome aboard!
JR
-
Welcome aboard Phil :cheers:
What mods do you have planned for the Wave?
I want to add a set of Rebar pliers for sure, 3D philips driver and an awl. I'm. It sure exactly where or how to fit them yet or what tools to take out, or which LMs are best to get them from but that's why I'm here.
If you're going to be slaughtering a Rebar for the pliers anyway, you should be able to get everything else you need from that too :tu: If you need help at any time, just shout. There's lots of people around here that have done mods with those tools :cheers: I have just made my Wave knifeless, and ground an awl from a Rebar driver. Mine has the dedicated drivers too
-
Welcome to :MTO: from one Phil to another :salute: :D
-
Thanks everyone!
-
Welcome to :MTO: , the friendliest forum on Earth! Enjoy your Wave! :multi:
-
Welcome aboard Phil :tu: