Multitool.org Forum
Tool Talk => General Tool Discussion => Topic started by: Syncop8r on July 17, 2018, 11:18:10 PM
-
There is often talk of this or that screwdriver being too short to access recessed screws, so show us the screws that were a screw too far. :pok:
:popcorn:
-
One interesting note--I've messed with a lot of screws a vintage (gray mag) inline Phillips on an SAK will get to, but the newer ones couldn't. Now with a CT-34, there's rarely a screw I can't get to. Pocket screwdrivers, particularly the reversible ones are a good addition (I used an old blue one from Granddad for two years before I could afford a CT34), especially if they've got another tool on top, often a magnet, but often other tools as well, usually a valve core tool, but often another driver or a bottle opener, both of which aren't seen that often.
-
I will get a pic or 2 if I remember :salute: :tu: