Text Only | Text with Attachments

Multitool.org Forum

Tool Talk => The Mod Squad => Topic started by: aikon2014 on March 08, 2018, 01:04:49 PM

Title: Washers?
Post by: aikon2014 on March 08, 2018, 01:04:49 PM: Is there any place where one can find teflon and/or phosphor bronze and/or brass washers that are thin enough and right size to fit most folding knives and Leathermans? :)

Btw, I would like to buy in bulk, or at least like 20 pairs or something like that at least. Or even better Teflon washer sheets so that I can cut out my own size washers!
Title: Re: Washers?
Post by: Wspeed on March 08, 2018, 01:54:21 PM: Where do you come from aikon
There are a couple of good American sites you could try :tu:
Link : https://www.knifekits.com/vcom/index.php?osCsid=hc7dugbp8k8lj3tgsk6ips1sh5
Link : http://usaknifemaker.com
Title: Re: Washers?
Post by: hiraethus on March 08, 2018, 01:56:13 PM: I've seen mylar sheet used as washers on here somewhere. By PTRSAK, I believe.

Cutting your own from brass sheet is not recommended. :ahhh
Title: Re: Washers?
Post by: aikon2014 on March 21, 2018, 01:11:07 PM: Screw it, so annoying translating metric to inches and so on, plus it seemed hard to find the right diameter. I'm just going to get a couple of sheets of ptfe/teflon and make my own washers.