bit extender

scrappy · **on:** May 24, 2008, 05:25:43 PM

I got a bit extender and getting the bits out of it is near impossible. is their a trick? I wonder if the bit adapters are the same?

J-sews · **Reply #1 on:** May 24, 2008, 08:20:14 PM

I got a bit extender and getting the bits out of it is near impossible. is their a trick? I wonder if the bit adapters are the same?

You're talking about this thing right?

The hex hole is designed for double-ended hex bits. Are you using single ended bits?

scrappy · **Reply #2 on:** May 25, 2008, 05:55:27 PM

I will try a double ended bit. I am using a single bit but it doesn't go in to far. the problem is that it sticks in there.

scrappy · **Reply #3 on:** May 25, 2008, 05:55:53 PM

jsews, thanks for the info

Leatherman123 · **Reply #4 on:** May 25, 2008, 06:16:03 PM

It can accept the LM "shaved" bits also.

J-sews · **Reply #5 on:** May 25, 2008, 08:46:44 PM

I will try a double ended bit. I am using a single bit but it doesn't go in to far. the problem is that it sticks in there.

Hmmm, like maybe the spring clip is too tight eh?