Re: Gerber Center Drive Club
« Reply #481 on: September 08, 2021, 08:26:12 AM »
After decades of pinched palms cutting wire with the MP600 it was time for a change. I knew what I wanted. A painless Gerber, with locking blades and a driver that accepted 1/4" bits. I looked around and there it was, with spring loaded pliers.
So far the CD gets used for basic light tasks. When things get serious I have real tools close at hand. I used it today to install a license plate frame. No I am not posting a image of my license plate, thank you very much. I'm not impressed with the Phillips bit, but that's unimportant, I'll replace it with a impact rated bit soon enough. I all ready removed the flat blade bit and a 1/4" socket driver rides in the bit holder now. A 3" bit extension is in the pouch with the bit assortment. Maybe I'll add a few common sockets in the future. I accept that the wire cutters are inadequate. I have real tools to cut wire. The pry tip is fine for small stuff. If I need more my GAK has it covered.