Alox Mod with cross head screwdriver ?

[Gee.B]

Hello,

Next week i will receive the Harvester I ordered on Amazon

Later this year i will most probably have it customized.

Not only would I like to have a keychain ring but also a cross head screwdriver.

I chose the Harvester because the claw shaped blade looks more useful to me than a short flat head screwdriver which I never have a use for nor do I see the usefulness of a can opener these days. A cross head screwdriver however is quite useful

Is this physically possible on Alox models ? Also, I believe this would add a layer to the knife so should I actually choose another function to make the most of this future mod ?

Thank you


Gee (from mobile)

[daverobson]

Hello,

Not only would I like to have a keychain ring but also a cross head screwdriver.

Is this physically possible on Alox models ? Also, I believe this would add a layer to the knife so should I actually choose another function to make the most of this future mod ?

Thank you


Gee (from mobile)

It certainly is possible as my Alox Explorer shows.

[Gee.B]

Ok that's great thanks for your reply.  Now this means another layer on the knife and then I would have to choose another tool at the opposite end

So by any chance,  is it possible to add a scraper similar to the one that i have on the Swisstool.  Is there one for regular SAK that is as good?

</Gee via Tapatalk>

[enki_ck]

You mean like the chisel part of it or the wire stripper?


If the second, then you can try sharpening the inside of the bottle opener with a round diamond file to make it like they used to be on the 93mm range. (Bob's pic)