Multitool.org Forum
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
+-

Hello Lurker! Remove this ad and much more by logging in.


Vise-grip, Irwin 212

Newbie Posts: 9
Vise-grip, Irwin
« on: February 13, 2021, 06:41:34 PM »
New set. Want it to last. Use WD-40 or?

Sent from my SM-G960U using Tapatalk

No Life Club Posts: 1,341
Re: Vise-grip, Irwin
« Reply #1 on: February 13, 2021, 09:39:27 PM »
Can't go wrong giving a tool a quick wipe down with a WD-40 dampened clean rag.

- Steve
No Life Club Posts: 1,592
Re: Vise-grip, Irwin
« Reply #2 on: February 13, 2021, 09:51:17 PM »
I prefer CRC 6-66 over WD40, although I do use both. Just seems to be that little bit better against surface rust.

"Simple is hard"
(Partial disclosure: I design tools for a living).
No Life Club Posts: 1,671
Re: Vise-grip, Irwin
« Reply #3 on: February 14, 2021, 02:02:07 AM »
Like smaller posted a thin coat of W-D40 works well. A thin coat will leave a varnish like coat of protection. If left wet it turns to a sticky mess.

I think Alcohol, Tabacco and Firearms should be a convenience store, not a government agency. 

Mike

 

Donations

Operational Funds

Help us keep the Unworkable working!
Donate with PayPal!
May Goal: $300.00
Due Date: May 31
Total Receipts: $79.60
PayPal Fees: $5.65
Net Balance: $73.95
Below Goal: $226.05
Site Currency: USD
25% 
May Donations

Community Links


Powered by EzPortal
SMF 2.0.17 | SMF © 2020, Simple Machines
Page created in 0.029 seconds with 33 queries.
© 2018 Defender Web & Tool