Multitool.org Forum
+-

Hello Lurker! Remove this ad and much more by logging in.


The Payback

us Offline Adam5

  • *
  • No Life Club
  • ******
    • Posts: 3,491
Re: The Payback
Reply #30 on: May 20, 2022, 03:24:23 AM
Also could you do a thread on modding the bit driver or link to one you used?  I have heard it takes welding on some extra material to the Center Drives bit driver.  Is that true?

When I enlarged the pivot hole, I did it somewhat off center from the original hole so that there was enough metal to engage the lock. I couldn't use the drill press because the drill bit would bend and align with the center of the existing hole. So I had to use my rotary tool and a couple of different sizes of Dremel chainsaw sharpening stones (5/32" and 7/32") to create a hole slightly larger than 7/32" and centered slight further away from the back end of the bit driver.

I wish I had documented the process. But I was focused on working out how to do the modifications and not so much on recording what I figured out.
« Last Edit: May 20, 2022, 03:47:10 AM by Adam5 »


Offline Hvac budget

  • Jr. Member
  • **
    • Posts: 69
Re: The Payback
Reply #31 on: May 21, 2022, 02:39:45 AM
Thanks.  It ended up fantastic!


us Offline Poncho65

  • Global Moderator
  • *
  • Just Bananas
  • *
    • Posts: 75,373
Re: The Payback
Reply #32 on: May 22, 2022, 01:57:43 AM
 :woohoo: :like:


 

Donations

Operational Funds

Help us keep the Unworkable working!
Donate with PayPal!
August Goal: $300.00
Due Date: Aug 31
Total Receipts: $36.00
PayPal Fees: $2.24
Net Balance: $33.76
Below Goal: $266.24
Site Currency: USD
 11%
August Donations

Community Links


Powered by EzPortal