on: December 30, 2023, 04:06:54 AM
I have had many SAK, a few Gerber Multitools, and a few Leatherman .
Always wanted a few more tools and finally after finding this forum, I have headed down the Mod path.
My full Mod List so far is as follows, this can be done on Wave+ or Charge Series.
1/ Rebar Awl swapped in place of Large Blade Screwdriver.(Straight Swap)
2/ moved Lanyard Loop to other side of handle.(To make more space near Saw)
3/ Sharpened Chisel end in Serrated Blade also gives space for Lanyard Loop.
4/ fitted titanium spacer tube to Saw end of handle.(To make space for extra removable tools that clip in with lock)
5/ Got removable Titanium Scribe/Pick from aliexpress and lives on spacer near Saw.(and locks in with blade lock)
6/ Tweezers (Leatherman) live under file in Belt Clip slot.
7/ Filed a notch in end cap/spacer allows SAK Toothpick to sit under Main Blade.
8/ Replaced the Hard Wire Cutters for EOD Cutters in Plier jaws so you can cut stranded wire.
(Hard wire cutters have a flat edge where EOD cutters have a sharp edge)
9/ Already had Hook Blade on Serrated Knife but you can file on Wave Serrated Knife.
...more to come...
- I still have 2mm of space beside the Scribe/Pick, for a thicker version of the scribe/pick with a rounded point as a marlin spike.
- I am looking at colour anodising & laser engraving the scales with a fibre laser.
I find I use the extra tools a lot and together with the Case, Bit Kit, Ratchet Driver Extension the Leatherman kit and Mods get used many times a day.
IMG_3611.jpg (Filesize: 317.25 KB)
Leatherman - 4 x Charge TTi+, Charge Ti, P4, Wave+,
Wingman, 2 x Rebar , Sidekick, Skeletool, Bit Kit Set, Ratchet Driver.
Gerber - Command 1, MT Suspension
SAK - Rescue Tool, Forester
Spyderco - Cara Cara Rescue2 FRN Orange
Mora 748MG green, Companion Spark
Michael - Brisbane, Australia.