Wave scales

[tattoosteve99]

Don't know if it's been done yet or even if it's possible. I likes the scales bushido made for the hammer mod that I just have to ask.

[bushidomosquito]

The wave doesn't have scales so you'd be adding thickness just for the color. I'm thinking about other tools that do have plastic that could stand to be replaced like the SOG toolclip and LM Style CS. How friggin cool would an olive green textured G10 Toolclip be? The Juice series could do with a splash of orange composite as well. I really like doing G10 scales. Somebody should send me a tool!

[tattoosteve99]

I would try to add them to the existing tool just for looks.  I like black so u would make then 1/8 inch thick. I believe that's the thinnest g10 I can get. Or maybe carbon fiber.

[Metropolicity]

Pretty much the only way to make scales is to find a used Charge. I know, since I made the mod, that 1/8" on either side will still tighten up correctly. The Charge TTI or XTI or TI would be your best candidate since the pivot screws are way easier to service than those stupid knurled screws (mine will never come off again)

I am looking at a Wave right now and you might be able to epoxy some carved and shaped G10 to it?

[WWW]

I would try to add them to the existing tool just for looks.  I like black so u would make then 1/8 inch thick. I believe that's the thinnest g10 I can get. Or maybe carbon fiber.

  I would love to see one with Carbon fiber scales!!!