Re: ZapWizard's Leatherman Free P4 Mods
« Reply #93 on: June 14, 2019, 07:56:48 PM »
Could I perhaps ask you to consider adding the LM 2D bit slot all the same? Or maybe an alternate model that has this instead of the transversal 4mm hex?
It would need to be an alternate model. I tried a few things today in CAD, but it works out to be too thin in critical places if I try to mix both together. I also realized I don't need a mixed horizontal opening, as the 1/4" wrench works well on the flat bits.
I did update the magnet stop to be smaller, this is live on the shop now. I have another batch of things to order, so I will get a new build, this time in a different finish. (The 24K gold plating is pretty, but it flakes off too easy for a tool)