You need to keep in mind that the plier head takes up space when closed. Because of that only the outer tools can be "high", the one in the middle needs to be "lower" to the base of the handle. The awl in the PST is high. I think you should be able to replace the outer screw driver on the side with the scissors. The knurly screws on the PST are hard to open. A little heat (e.g. soldering iron) helps. Or brute force if you only want to selvage the one part
Nice job mate
Nice job I think you need a washer to make up the difference in thickness between the awl and the two drivers removed.
Does it close?I took a look at my OG Wave. The scissors get slightly pushed to the side and thus straightened out by the middle screw driver's side. With the screwdriver open, it looks like your picture. I doubt that a circular spacer will be long enough to straighten out the scissors.
Nice, where did you get the washers ?
Quote from: SteveC on July 29, 2017, 09:49:27 PMNice, where did you get the washers ?An ebay seller from Taiwan, it was like $4 for a pack of them but it took two weeks to show up. The washers are intended for remote control cars. I could mail you one for the price of a stamp. I used a micrometer to figure out the size I needed. I found out later you can buy them in bronze from Knifekits.com, bronze might have been better but don't think it matters much.