[FOUND] Old Clipit Delica clip

[ThundahBeagle]

Anyone have a pocket clip system for an older model Clipit Delica? I've reached out to Spyderco via email but not yet heard back from them, and thought I would try here.

Thanks in advance, and if not, no worries.

[captain spaulding]

What does the clip attachment setup look like again? I believe one of the current model clips should work for it.

[ThundahBeagle]

Hi Cap'n

It's about a 5 or 6mm hole through the aft of the knife. Surrounding that hole is a square indented bezel, on both sides of the knife. I thought the new stuff was 3 little screw holes, though I may be wrong

[captain spaulding]

The current Spyderco Resure models clip should work perfectly for you.   

It’s called a barrel clip or something like that.

[captain spaulding]

Oh and it may be the Pacific Salt and Salt 1 clip.

[ThundahBeagle]

OK Cap'n

Yeah I was looking in the show us your spyderco thread and it seems like you said, a lot of newer stuff with the barrel clip will work.

Thanks Cap'n

[ThundahBeagle]

While I never heard back from Spyderco after I emailed them, I did decide to give them a call and make the selection for the store.

I spoke with Candi and I have to say, friendly customer service is what I got. I ordered up a new barrel clip for this Delica, and they were pleased as punch to have a new fan and customer, even though I only needed a clip...for now.

Candi took my address and said the clip will go out tomorrow.  It should arrive in 5 to 7.

Thanks Cap'n and anyone else who took the time to check this thread out to see if they might help.