Making A Pocket Pry Bar
-
The one I have on my keychain is a micro pry bar, 5" I think, that came from my local hard wear store. I cut it to the length I wanted then sharpened the end opposite the pry bar into a flat head screw driver. I don't think plain mild steel will hold up very good, especially the scraper/pry bar.
Here's mine.

-
@tattoosteve99 said:
I just bought a small one, like 4 inches long, from home depot. Cut off the really bent part, drill a hole in it, attach key ring and done.Who makes yours? I am heading to home depot shortly now to see if I can pick one up.
-
I just bought a small one, like 4 inches long, from home depot. Cut off the really bent part, drill a hole in it, attach key ring and done.
Who makes yours? I am heading to home depot shortly now to see if I can pick one up.
Lol I don't remember exactly. There aren't many small ones. Just pick the that's blue I think.
-
I had an old 4 inch Craftsman that I did the same thing.Cut off the bent part,drilled a hole in the end and wrapped it with paracord.I carry it in my EDC pouch.
-
I tried that. Picked up a small cheap pry bar, cut it off to length, rounded the cut end with a bench grinder, and attempted to drill the hole. None of my bits will penetrate that steel. I looked at buying a carbide bit but at $22 it puts the cost of the project over budget.
-
Heat it up drill it. Heat it up again and quench in oil. Done. You may have to repaint or blacken it.
-
The small pry bars i have been using to make mini pry bars i have been buying at sears for 2.00.
Mike -
I just picked up a Vaughan Mini bar (the blue one Steve!) for $5 at home depot. I cut it off with my dremel and ground a radius on the end for comfort, then drilled a #1 hole for a paracord lanyard. After deburring that hole and doing a bit of adjusting to the angle on the prying end, I dropped in in some solvent to dissolve the remaining paint and it should be done soon. When it is I may shoot it with a black Enamel to prevent rust. I just didn't like the blue. If I like this one enough then I will be picking up a micro widgy from Countycomm.
-
You can also remove the paint with a wire wheel buffer if you have one. I gave a few away that i blued with gun bluing they turned out sweet.
Mike -
I need to try something like that. I don't have any chems strong enough to loosen paint ATM. I had a paint removal wheel for my dremel but it has gone missing and none of the wire wheels I have for it will even touch this paint. Luckily I work in a Collision Repair shop so my painter will have something for me that should do the trick.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
