Brewzer: 1/4" Hex Drive?

JNieporte · **on:** July 20, 2013, 02:40:44 AM

I just got three Brewzers for review, and noticed that the inside of the bottle opener isn't rounded; it has squared edges. Sure enough, a 1/4" hex bit fits in it perfectly. All three are like this. Despite seeing many photos of the Brewzer on-line, there's no mention of this feature. Not even on here.

Here's an image of the Brewzer; look inside the bottle opener.

It works just fine; anybody else notice it?
(The Brewzers referenced are made by Leatherman, not Pocket Tool X.)

DeezNittles · **Reply #1 on:** July 20, 2013, 03:18:03 AM

A lot of the YouTube reviews for the Brewzer discuss this feature.

enki_ck · **Reply #2 on:** July 20, 2013, 04:28:09 AM

Welcome back.

JNieporte · **Reply #3 on:** July 20, 2013, 05:33:53 AM

Quote from: enki_ck on July 20, 2013, 04:28:09 AM

Welcome back.

Not back.

Just had a few minutes to spare. I'm still recovering from some health problems, plus a new one crept up. The Brewzer is the first tool I've gotten in months.

Breezy12 · **Reply #4 on:** July 20, 2013, 07:48:25 AM

Quote from: JNieporte on July 20, 2013, 05:33:53 AM

Quote from: enki_ck on July 20, 2013, 04:28:09 AM
Welcome back.

Not back.
Just had a few minutes to spare. I'm still recovering from some health problems, plus a new one crept up. The Brewzer is the first tool I've gotten in months.

Well, even if you're not "back", it's good to hear from you again.