Card holder

pfrsantos · **on:** October 13, 2020, 01:32:07 PM

I used to carry awl my cards in a small metal cigarette case. I recently reduced the number of cards I carry, managed to just use my wallet (might make a post on it, too).

I needed some kind of card holder for my public transport pass. Don't want to have to take out my wallet everytime I need to use my pass. So...

Looked for a small piece of leather. Measured it, cut a small rectangle, punched some holes, stitched it up. Took me about 5-10 minutes.

Don Pablo · **Reply #1 on:** October 13, 2020, 01:35:10 PM

Neat thing and good execution

pfrsantos · **Reply #2 on:** October 13, 2020, 01:57:28 PM

Quote from: Don Pablo on October 13, 2020, 01:35:10 PM

Neat thing and good execution

Thanks. Could be better. I don't think this is cow leather, it's way to soft and thin. When punching the holes, the leather stretched a little, that's why the stitch line is not very straight.

I had to be careful, not to make the stitching too tight, so as not to cut the leather with the thread (that's how soft it is).