Next project

[neverused]

While I was working on the "Gentleman Farmer," I began carrying my Vic Farmer and have begun to really like the 93mm alox.  I have been toying with the idea of adding scissors, maybe tweezers too, to a Farmer.  However, before I begin this project, I was wondering what combos sounded the most useful:

1)
Large blade/ awl
Scissors
Saw
Combo tool/ Pruning blade

2)
Large blade/ awl
Scissors
Saw
Bottle Opener/ Can Opener

3) Other combinations of a Compact/ Farmer/ Harvester/ Etc.

Do you have any suggestions?

[MirrorEdge]

The first one is the best , but i dont think that this is possible .

[neverused]

I don't see why the first one wouldn't be possible, although the nail nick for either the combo tool or the pruning blade will be on the wrong side. 

Can anyone tell me any reason why my first idea wouldn't work before I go about getting and then tearing apart two knives?

Thanks

[tattoosteve99]

#1. And it will work. Just use a 91mm combo tool

[Rahmed]

+1 for #1
Of course it is possible, I tried it now Go ahead

[neverused]

Rahmed, do you mind if I ask what you tested? Was it the combo tool/ pruning blade layer?  I'm second guessing myself...

[tattoosteve99]

I think he did both. I know he tested a combo tool on a 93 cause I saw it.

[neverused]

I think he did both. I know he tested a combo tool on a 93 cause I saw it.

You saw him put the two in the same layer?

Sent from my DROID2 GLOBAL using Tapatalk

[tattoosteve99]

I saw the combo tool with a blade. I used a electricians knife with an awl. I can do a test fit for you if I had a pruner blade. I'm sure it would fit though. Try it before you enlarge the hole and test. I do that all the time just to check tools.

[neverused]

I saw the combo tool with a blade. I used a electricians knife with an awl. I can do a test fit for you if I had a pruner blade. I'm sure it would fit though. Try it before you enlarge the hole and test. I do that all the time just to check tools.

Awesome thank you

Quick question: are the pins on a 93mm SAK 2.5mm?

Sent from my DROID2 GLOBAL using Tapatalk

[tattoosteve99]

I saw the combo tool with a blade. I used a electricians knife with an awl. I can do a test fit for you if I had a pruner blade. I'm sure it would fit though. Try it before you enlarge the hole and test. I do that all the time just to check tools.

Awesome thank you

Quick question: are the pins on a 93mm SAK 2.5mm?

Sent from my DROID2 GLOBAL using Tapatalk

The tool pins (on each end)are 3mm and the spring (one in middle) are 2.5.