Yeah, I know, but this time it's because of the movement of the bolster it's attached to. Did you see the dirty big gap?
I buy used tools so any issues I may run into i don't fuss about too much. Chako, LM should not be treating any customer as if they are lucky to buy from them let alone make it hard to buy from them.
I do now, is it because it's loose or is the gap the regardless of how tight the bolster is ?
...... Big, but justified Chakorant...... I typed all of this on my cell phone...I need a good
I'm not bothered about the clip really, it's more the poorly fitted wobbly bolsters that annoy me. Other tools don't have that problem, the Wave is nice and tight in that area (snigger), but that gap when the bolster's twisted is close to 2mm!
It's as tight as it can be ... I was up a ladder with only one hand free trying to wrestle it out of my jeans... the tool... the Leatherman.
I'm carrying a Wave (08/10) today and the difference in tolerances is staggering. Just look at that, almost as solid and close fitting as my fantastically tight jeans! (Image removed from quote.)And for comparison, the Surge again:(Image removed from quote.)
I'm done with LM and Gerber...and SOG..... Any company without the pride to produce a quality tool....every time...is of no interest to me.
Like, that's a huge gap. Is it the bolster or the side panel that is too short and causing the gap?
I feel the same for quite a while I must say I've acquired some of the good old ones that serve me well. And that seems to be it for now.
Ja. I have some old gems. Thank goodness for that!